We took the cameras down today for a short maintenance period. They will be back up soon!
The large waves and elevated levels of sand and particles in the water have been saturating with the cameras and clogging the image processing pipeline. To keep both cameras running, the SPC2 was reduced to 2 FPS down from 8. An example of just how many particles are in the water is shown below. Note the large number of very small particles in the background, the overall glow behind the mysid, and the blurry spots in front and behind the mysid.
After some strong surf and rough conditions, we had a window to clean the cameras this week in some very poor visibility. With the cameras clean and running well, we are capturing a bloom of ceratium amidst the many, many sand particles suspended by the swell. Below is a view from the SPCP2 showing just how many ceratium are showing up in the camera. These were filtered to a size range of 0.05 mm to 0.15 mm with an aspect ratio of 0.1 to 0.3.
A nice example of perhaps Calanus pacificus
Last week we completed our six month maintenance on the cameras. This included pulling both cameras out of the water, extensive cleaning of the housings and frame, and fixing several issues. In addition, we migrated most of the optical ports to sapphire and added UVC LEDs in a test configuration to study how they might be used to reduce bio-fouling.
Below are a few photos of the cameras after being pulled out of the water and cleaned.
You may have noticed recently that the SPC2 camera with the 1-5 mm size preset shows lots of fish fins lately. This is a result of a rather large school of small (0.5 to 5 cm) long fish that have started using the cameras as a shelter. Today we removed the previous copper mesh with a 1.2 cm opening and replaced it with a 0.5 cm opening mesh. This should be smaller than the majority of fish around the cameras and will hopefully limit the number of nuisance images of fish fins. The video below shows the new mesh installed and the plethora of fish surrounding the cameras. In addition we recorded some footage of the amazing visibility today and some other ocean friends.
We had a short downtime today while the software software was updated to the latest version.
We (Eric and Paul) dove on the cameras today to do a much needed cleaning. The SPC2 strobe port was highly fouled again resulting in a bright background in the images. To mitigate this, we added a black shroud around the sun facing side of the SPC2 ports to block direct sunlight from hitting the up looking port. We hypothesize that this was the primary cause of the rapid bio fouling on that port.
Eric and Paul cleaned the cameras today. The SPC2 strobe port was very fouled (see video below) but otherwise the ports were not too bad. We removed lots of growth on the system and verified the pumps are still working.